ÉPIX™ Drive 640 User Manual
Page 10 of 14
Mounting
Before mounting this product, r ead the Safe ty Notes in this Us er Manual.
Orientation
Always mount this product in a sa fe position and make sure there is
adequate room for ventilation, configuration, and maintenance.
Rigging
The ÉPIX™ Drive 640 ha s six (6) mounting points with 10 mm hol es.
CHAUVET® recommends using the following general guidelines
when
mounting this product:
•
When selecting an installation location, consider easy access to this
product for opera tion, programmi ng adjustments, and routine
maintenance.
• Make sure to mount this product away from any flammable materi al
as indicated in the Safety Notes section.
• Never mount in place s where rain, high humidity, extre me
temperature changes, or restricted ventilation may affect the product.
• If hanging this prod uct, make sure th at the mounting loca tion can
support the product’s weight. Refer to the Technical Specificat ions
section for the wei ght-bearing requirements of this product.
Procedure
The ÉPIX™ Drive 640 has four (4) mounting points (one on each corne r)
with 10 mm holes to which you can install screws and mount
this product
directly to almost any flat surface in any orientation.
The ÉPIX™ Drive 640 also has two (2) mounting poi
nts centered on each
end of the product to install clamps for hanging. You must
supply your
own clamps and make sure the clamps
are capable of supporting the
weight of this product.
Product
Mounting
Diagram