1.BEFORE YOU BEGIN
What is included
1 x Hurricane™ 700
1 x Wired Remote
1 x Warranty Card
1 x User Manual
1 x Fluid (0.6L)
Unpacking Instructions
Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.
AC Power
| To determine the power requirements for a particular fixture, see the label affixed to the back plate of |
| the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average |
| current draw under normal conditions. All fixtures must be powered directly off a switched circuit and |
| cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer |
| channel is used solely for a 0% to 100% switch. Before applying power to a fixture, check that the |
| source voltage matches the fixture’s requirement. Check the fixture or device carefully to make sure |
| that if a voltage selection switch exists that it is set to the correct line voltage you will use. |
Warning! | Verify that the voltage select switch on your unit matches the line voltage applied. |
| Damage to your fixture may result if the line voltage applied does not match the |
| voltage indicated on the voltage selector switch. All fixtures must be connected to |
| circuits with a suitable Earth Ground. |
Hurricane™ 700 User Manual | 3 | 12/23/2008 6:02 PM |
