AC Power
| To determine the power requirements for a particular fixture, see the label affixed to the back plate of | |
| the fixture or refer to the fixture’s specifications chart. A fixture’s listed current rating is its average | |
| current draw under normal conditions. All fixtures must be powered directly off a switched circuit and | |
| cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer | |
| channel is used solely for a 0% to 100% switch. Before applying power to a | Figure 1 - AC Voltage Switch |
| fixture, check that the source voltage matches the fixture’s requirement. |
|
| Check the fixture or device carefully to make sure that if a voltage selection |
|
| switch exists that it is set to the correct line voltage you will use. |
|
Warning! | Verify that the voltage select switch on your unit matches the |
|
| line voltage applied. Damage to your fixture may result if the |
|
| line voltage applied does not match the voltage indicated on | Not all fixtures have a voltage |
| the voltage selector switch. All fixtures must be connected to | |
| select switch. Please be sure to | |
circuits with a suitable Earth Ground.
Contact Us
World Wide
connect to the proper voltage.
General Information | CHAUVET | |
| 3000 North 29th Court | |
| Hollywood, FL 33020 | |
| voice: | 954.929.1115 |
| fax: | 954.929.5560 |
| toll free: 800.762.1084 | |
Technical Support | CHAUVET | |
| 3000 North 29th Court | |
| Hollywood, FL 33020 | |
| voice: | 954.929.1115 (Press 4) |
| fax: | 954.929.5560 (Attention: Service) |
World Wide Web | www.chauvetlighting.com | |
LXW User Manual | 3 |
