Appendix
General Troubleshooting
Applies to
Symptom Solution(s) Lights Foggers
& Snow Controller
s Dimmers
& Chaser
Auto shut off Check fan thermal switch reset 9
Beam is very dim or
not bright Clean optical system or replace lamp
Check 220/110v switch for proper setting 9
Breaker/Fuse
keeps blowing Check total load placed on device 9
Chase is too slow Check users manual for speed adj ustment 9 9 9
Device has no
power Check for power on Mains.
Check device’s fuse. (internal and/or exter na l) 9 9 9
Fixture is not
responding Check DMX Dip switch settings for correct
addressing
Check DMX cables
Check polarity switch settings
9
Fixture is on but
there is no
movement to the
audio
Make sure you have the correct audio mode
on the control switches. If audio provided via
¼” jack, make sure a live audio signal e xists
Adjust sound sensitivity kn ob
9
9 9
Lamps cuts off
sporadically Possible bad lamp or fixture is overheating.
Lamp may be at end of its life. 9
Light will not come
on after power
failure
Some discharge lamps require a cool ing off
period before the electronics i n the fixture can
kick start it again, wait 5 to 10 minutes before
powering up
9
Loss of signal Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power
cables or black lights.
9 9 9 9
Moves slow Check 220/110v switch for proper setting 9
No flash Re-install bulb, ma y have shift ed in shipping 9
No laser output Bounce mirror motor may have shifted d urin g
shipping, readjust 9
No light output Check slip ring & brushes for contact
Install bulb
Call service technician
9
Relay will not work Check reset switch
Check cable connections 9
Remote does not
work Make sure connector is firmly connected to
device 9 9
Stand alone mode All Chauvet lighting fixtures fe aturing stand-
alone functions do not require additional
settings, simply power the fixture and it will
automatically enter into this mode
9
TFX-64CM User Manual 21 Revision: 2006-11-30/17:23