1.If there is interference from similar metal detectors in your searching area, lower the DISCRIMINATION and adjust the TUNE setting to stop the interference. You may also need to rebalance the Metal Detector.
2.If there is interference from electrical cables, TV, radio, or other electrical devices in your searching area, lower the DISCRIMINATION setting.
3.When searching in highly mineralized areas, the unit may sound even
if there is no metal. Lower the DISCRIMINATION setting and increase the distance of the Search Coil from the ground until the false signal disappears. You may also need to rebalance the Metal Detector.
4.When searching in a trash area, set the DISCRIMINATION to the middle setting so that the unit can reject most invaluable metals such as nails, bottle caps, cans, and small pieces of iron.
5.Move all metal digging tools away from the Metal Detector when searching.
Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation: Turn the Power Switch of the tool off and remove the batteries from the tool before performing any inspection, maintenance, or cleaning procedures.
Do not use damaged equipment. Have the problem corrected before further use.
Cleaning and Maintenance
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose hardware, misalignment or binding of parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.Handle the Metal Detector gently and carefully. Dropping it can damage circuit boards and the case, and can cause the Detector to malfunction.
3.After Use, wipe external surfaces of the tool with a damp clean cloth, then dry. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the detector.
SKU 43150 | For technical questions, please call | Page 11 |
