SpecificationsAssembly
Electrical Requirements | 120 V~ / 60 Hz / 6.3 A |
|
|
Motor No Load Speed | |
|
|
Chuck Capacity | 3/64 to 1/2”, plus key |
| chuck |
Chuck Thread | 1/2" - 20 UNF |
E194601
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Housing (29) | Auxiliary Handle (501) |
| Chuck (2) |
Depth Gauge (502)
Wing Nut
Figure D
1.Insert the Auxiliary Handle (501) over the Housing (29) until it rests behind the Chuck (2). When required for exact depth drilling, insert the Depth Gauge (502) into the Auxiliary Handle clamp. See Figure D.
2.Turn the Forward Handle for left or
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
SKU 45338 | For technical questions, please call | Page 9 |
