SKU 45416 Page 5 REV 04/02
MOUNTING PLATE

FOR

GENERATOR / ALTERNATOR 10KWSKU 45416
A mounting plate (not included), similar to the one illustrated below, will need to be provided by the
customer to properly and safely mount and operate the generator/alternator. The plate is needed to
properly tension the drive belt used to drive generator/alternator. Drawing below is for reference only
and customer may need to make further modification to mounting plate and their generator frame for
the proper and safe mounting of the generator/alternator. The drawing gives dimensions for the plate
and generator/alternator footprint.
THE MANUFACTURE AND OR DISTRIBUTOR HAS PROVIDED THE MOUNTING PLATE DIAGRAM AS A
REFERENCE TOOL ONLY . THE CUSTOMER CAN CHOOSE TO DESIGN, MANUFACTURE AND USE THEIR
OWN MOUNTING PLATE. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER
MANUFACTURING OF A MOUNTING PLATE THAT IS NOT INSTALLED PROPERLY AND SAFELY
MANUFACTURED.
DRAWING NOT TO SCALE, FOR REFERENCE ONLY !!
Note: Performance of this tool may vary depending on variations of the power driver motor .
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Material: 1/2” steel plate