INSPECTION, MAINTENANCE, AND CLEANING
1.CAUTION: Always disconnect the Vacuum/Blower from its electrical supply source before performing and inspection, maintenance, or cleaning.
2.Before each use, inspect the general condition of the Vacuum/Blower. Check for broken parts, damaged power cord, and any other condition that may affect its safe operation. If a problem with the Vacuum/Blower occurs, immediately discontinue using the tool and have the problem corrected before further use. Do not use damaged equipment.
3.Before each use, remove the Motor Housing (3) from the Container (20). Empty all debris/liquid from the Container. Check to make sure the Bag (19) is clean. If necessary, remove the Rubber Band (18) and Bag from the Ball Basket (17).
Clean the Bag. Then, replace the Bag, Rubber Band, and Motor Housing.
4.Do not use solvents to clean the Vacuum/Blower, as damage to the tool may occur. To clean, use a damp cloth. If necessary, a mild detergent may be used. Then, completely dry.
5.When storing, keep the Vacuum/Blower in a box or covered with a cloth cover.
PARTS LIST
PART # | DESCRIPTION | QTY |
| PART # | DESCRIPTION | QTY |
|
|
|
|
|
|
|
1 | Switch | 1 |
| 12 | Screw Cap | 1 |
2 | Screw (5 x 18) | 7 |
| 13 | Worm Cover 8mm | 1 |
3 | Motor Housing | 1 |
| 14 | Screw (4 X 18) | 6 |
|
|
|
|
|
|
|
4 | Power Cord | 1 |
| 15 | Stator | 1 |
|
|
|
|
|
|
|
5 | Motor | 1 |
| 16 | Ball | 1 |
|
|
|
|
|
|
|
6 | Screw (3 x 8) | 4 |
| 17 | Ball Basket | 1 |
|
|
|
|
|
|
|
7 | Screw (4 x 16) | 2 |
| 18 | Rubber Band | 1 |
|
|
|
|
|
|
|
8 | Motor Fixer | 1 |
| 19 | Bag | 1 |
|
|
|
|
|
|
|
9 | Bushing | 1 |
| 20 | Container | 1 |
|
|
|
|
|
|
|
10 | Impeller | 1 |
| 21 | Hose | 1 |
|
|
|
|
|
|
|
11 | Washer | 1 |
| 22 | Hose Attachment | 1 |
|
|
|
|
|
|
|
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSEDTECH- NICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 90981 | Page 7 | REV 03/04 |
