Chicago Electric 91214, 91212, 94336 Replacing the Lens cover, For sku 94337, Frame

Replacing the Lens cover	Frame (1)
for sku 94337 and 94336.

1. Replace the Front Lens Cover (2) if it is damaged (cracked, scratched, soiled or pitted).

TabTab

Tab

Tab

Press tabs up with a screwdriver to remove Frame (1).

a. To remove the Front Lens Cover (2)

first remove the frame (1). Inside the helmet on the cartridge there are 4 tabs, (two on the top and two on the bottom). Use a small flat-head screwdriver to pry the frame (1) off the helmet.

b. Pull off the Frame (1).

c. Remove the protection film from both sides of the new Lens if it comes with the film on. Place the new Lens into the right position by bending it slightly, enough to fit in between the tabs at each side of the lens and putting the lens in place.

d. Check and make sure that the Lens is securely installed.

2.Clean the Filter Lens with a clean lint- free tissue or cotton cloth.

3.Do not immerse the lens in water or any other liquid. Do not use abrasives, solvents or oil based cleaners.

4.To remove the Auto-Darkening Filter (3): Open the Spring (15) inside the helmet, remove the Shade Knob (4), loosen the nut holding the shade dial to the helmet, and remove the dial and filter. Do not try to open the Auto- darkening Filter (3).

5.Re-attach the frame by pressing it back on over the cartridge from the front. Secure it using the tabs inside the helmet.

6.Storage temperature: -4 to 158° F.

REV 07j; 10c

Page 8	For technical questions, please call 1-800-444-3353. Auto-darkening
	Welding Helmet