Chicago Electric 91938 General Operating Instructions, SKU For technical questions, please call

Upper Two Screw Holes

Bolts (41 & 44)

Angle Scale (35)

FIGURE 5

b. To cut at various angles (up to 45 degrees), adjust the Angle Scale (35) by loosening the two Bolts (41 & 44) as shown in FIGURE 5. Adjust the Angle Scale to the desired setting and then tighten the Bolts (41 & 44).

c.To reposition the Angle Scale (35), remove both of the Bolts (41 & 44), and reattach the Angle Scale at the upper two screw holes. See FIGURE 4.

4.There must not be objects, such as utility lines, nearby that will present a hazard while working.

General Operating Instructions

TO PREVENT SERIOUS INJURY:

Do not operate with ANY guard disabled, damaged, or removed. Moving guards must move freely and close instantly. Bolt (112) MUST be loose before operation.

1.Using the vise, secure your workpiece and, if necessary, adjust the angle of the cut.

2.Raise the Saw by pushing down on it and pulling out the Lock Ball (25).

3.Plug the Power Cord into the nearest

120 V~, grounded, electrical outlet. Slide the Trigger Lock and pull the Trigger to

start the Saw. Allow the Cut-Off Wheel to attain full speed.

4.With one hand on the Handle and the other hand clear, slowly bring the Saw down onto the Base, letting the Saw do the work. Do not apply excessive force.

5.If the Cut-Off Wheel does not cut all the way through the workpiece, raise the Saw and release the Trigger. Unplug the unit. Wait until the unit comes to a full stop. Remove the workpiece. Set the depth adjustment to a deeper setting. After adjusting the depth, bring the Saw all the way down to make sure the Cut- Off Wheel doesn’t contact the Base. If it does contact any part of the Base, re- adjust the depth so it doesn’t.

6.Repeat the cutting process starting with number 1 above.

7.Once the cut is completed, turn off the Saw by releasing the Trigger and unplug the unit. Do not attempt to remove the workpiece until the Cut-Off Wheel has stopped moving.

8.To prevent accidents, turn off the tool, disconnect its power supply, and lock it down by pushing it down as far as it will go, and then pushing the Lock Ball (25) in after use. Clean, then store the tool indoors out of children’s reach.

SKU 91938 For technical questions, please call 1-800-444-3353. Page 11