INSPECTION, MAINTENANCE, AND CLEANING
1.
WARNING! Make sure the Power Switch (20) of the Masonry Saw is in its “OFF” position and the tool is unplugged from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
2.Before each use, inspect the general condition of the Masonry Saw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring and any other condition that may affect their safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.Before each use, inspect the Saw Blade (15). Using a dull Saw Blade will cause excessive wear on the Motor of the Masonry Saw and will not produce a satisfactory cut. Replace with a new Saw Blade when needed. (See Figure F.)
4.To clean the exterior parts of the Masonry Saw, use only a clean cloth and mild detergent to clean the body of the Saw. Use a vacuum to clean the Motor ventilation slots located on the Motor Rear Cover (24). Do not immerse any electrical part of the tool in any liquids.
5.
CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.
SKU 93218 | For technical questions, please call | Page 14 |
