If the blade becomes twisted or misaligned in the cut, the teeth at the back edge of the blade can dig into the top surface of the wood causing the blade to climb out of the kerf and jump back toward the operator. Kickback is the result of tool misuse and/
or incorrect operating procedures or conditions and can be avoided by taking proper precautions as given below:
Maintain a firm grip on the saw and position your body and arm in a way that allows you to resist kickback forces. Kickback forces can be controlled by the operator, if proper precautions are taken.
When blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. Investigate and take corrective actions to eliminate the cause of blade binding.
When restarting a saw in the workpiece, center the saw blade in the kerf and check that teeth are not engaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted.
11.Use extra caution when making a “Pocket Cut” into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback.
12.Maintain labels and nameplates on the Saw. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
13.Always wear
14.Maintain a safe working environment. Keep the work area well lit. Make sure there is adequate surrounding workspace. Always keep the work area free of obstructions, grease, oil, trash, and other debris. Do not use a power tool in areas near flammable chemicals, dusts, and vapors. Do not use this product in a damp or wet location.
15.Avoid unintentional starting. Make sure you are prepared to begin work before turning on the Saw.
16.Do not force the Saw. This tool will do the work better and safer at the speed and capacity for which it was designed.
17.Always unplug the Saw from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
18.Never leave the Saw unattended while running. Turn power off and unplug the power cord if you have to leave the Circular Saw.
19.Before each use, check all nuts, bolts, and screws for tightness.
20.Keep extension cord off the ground and away from water.
21.Always connect the Power Cord to a Ground protected electrical outlet.
SKU 94626 | For technical questions, please call | Page 6 |
