Charging the Battery
1.Insert the Charger Adapter (24) cord plug into the unit connector as shown below.
2.Plug the Charger Adapter module into an electrical outlet. The red Charging Indicator on the Cordless Screwdriver will light. Charge the new battery for 10 hours. When the battery is fully charged all three LEDs will light up. Remove the Charger Adapter (24) from the electrical outlet. The red Charging indicator will turn off. See Figure D.
Testing the Battery Charge
|
| Figure D |
| Front Operation Light |
|
|
|
| |
|
|
|
| Front Operation Light Switch |
|
|
|
| |
|
|
|
| Charging Indicator LEDs |
|
|
| Charging Test Button | |
Charging Adapter Cord |
|
|
| Charging |
|
|
| ||
|
|
|
| Adapter (24) |
Push the charging test button to display battery power. All three LEDs lit means the battery is fully charged. Two LEDs lit indicate that the battery is half charged. One LED lit indicates that the tool should be charged. See Figure D above.
Caution: Do not overcharge the Battery. Never charge for more than 10 hours continu- ously. Charger Adapter should not be left plugged in after charging is complete.
Operating instructions
1.Snap in the desired hex driver into the front of the Cordless Screwdriver. See Figure E below.
2.If light is needed while driving screws, turn on the Front Operation Light Switch (see Figure D for its location). The light will turn on when the Trigger Switch is on.
3.Engage the screwdriver bit over the item being turned. The bit size must match the size of the item being turned.
Figure E
Insert Screwdriver
Bit Here
Screwdriver Bits
4.Squeeze and hold the top part of the Trigger Switch
(14) to begin clockwise operation. For counterclockwise operation, squeeze the lower part of the Trigger Switch.
SKU 95065 |
| REV 07a |
For technical questions, please call | Page |
