4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
General Operating Instructions
1.To turn ON the tool, squeeze the Trigger (60). To turn the tool OFF, release the Trigger.
2.The tool can be set to operate continuously, by squeezing the
Trigger and pressing in the Locking
Button on the Handle. To stop continuous operation, squeeze the Trigger to unlock the Button and release the Trigger.
3.Be sure the work piece is firmly mounted so it will not move during the cutting operation. Support the cut off end of the work piece so it will not fall free at the end of the cut.
4.Grip the tool with both hands, one hand on the Handle (58,65), and one on the Front Cover (42).
5.Place the Blade (43) on the work piece and squeeze the Trigger (60). The saw will begin to operate.
6.Keep the Base Plate (44) pressed firmly against the work piece to prevent tool kick back.
7.Maintain a smooth motion pressing the Blade through the material as it is cut. Follow the cut, do not press too hard. If the tool slows down as it is cutting, apply less pressure on the tool.
8.When the cut is completed, release the Trigger and wait until the blade stops. If you will not be making
another cut unplug the tool and store it safely.
Plunge Cutting
1.You can plunge cut into plywood and thin board panels. Do not attempt to plunge cut into thick, hard or metal panels.
2.Select a short, thick blade which is in good condition.
3.Place the tool on the work piece with the Blade NOT touching the work material. Squeeze the Trigger (60) to start the tool operating. Never start a plunge cut with the Blade tip touching the work piece. This will cause an immediate kick back, that can damage the work piece, blade or cause injury.
4.Slowly rotate the tool on the Base Plate (44) as the Blade contacts the work piece. Hold the tool firmly.
5.Continue to slowly rotate the tool until the Blade has penetrated through the work material. Press the Base Plate
(44) firmly against the work material and continue to make the cut.
6.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool in- doors out of children’s reach.
SKU 97580 | For technical questions, please call | Page 11 |
