Using the Rear Bench Seat
•Push the bench seat to its most rearward position.
•NOTE that there are webbing straps attached to the bottom of the rear seat pad. These straps will lock the seat into the most rearward position. To lock the seat, pull the straps from EACH side of the pad and loop them around the frame as shown, then snap them together. See Figure 23. To slide the seat forward, undo EACH snap and reattach the webbing to the underside of the seat pad using the hook and loop attachments.
•Position the canopy to its most forward position.
•Have the child sit on the bench seat facing backward with their feet on the platform.
•You may need to adjust the position of the seatback to allow for more room for the child to sit.
•Unlatch the waist buckle by squeezing the latch releases on both sides of the buckle and removing the male ends of each buckle.
•Place the crotch strap between the child’s legs.
•Bring the seat belt around the child’s waist and insert the male ends of the waist buckle into the female buckle. Ensure that they snap into place. Tighten the waist belt to be snug around the child’s waist. See Figure 24.
•Adjust the seat belt to be snug around the child’s waist.
•Be sure that the BOTH of the child’s feet are fully on the platform at all times.
•Be sure that BOTH of the child’s hands are holding the handles on the frame.
Figure 23 | Figure 24 |
!WARNING
NEVER allow a rear seated child to use the canopy as a hand hold.
Caboose Ultralight Instruction Manual | Page 11 |
