Christie Digital Systems 38-RS1002-01 APPENDIX

APPENDIX

Wireless Remote Control Unit is not only able to operate this projector but also usable as a wireless mouse for most

Personal Computers. POINT buttons and two CLICK buttons are used for wireless mouse operation.

This Wireless Mouse function is available only when PC mouse pointer is displayed on a projected screen. When ON-

SCREEN MENU or any message / dialog box is displayed on screen instead of PC mouse pointer, this Wireless Mouse

function can not be used.

Connect mouse port (or USB port) of your computer to Control

Port (or USB connector) of this projector with Control Cable (or

USB cable). (Refer to page 13, 14 for connection.)

Turn a projector on first, and then turn on your computer. When

computer is switched on first, Wireless Mouse may not work

properly.

To use Wireless Remote Control Unit as Wireless Mouse for a Personal Computer, installation of mouse driver (not supplied)

is required. Make sure that mouse driver is properly installed in your computer. And make sure that mouse port (or USB

port) of a Personal Computer is activated.

When controlling a PC mouse pointer, operate Wireless Mouse with POINT button, SELECT button, and RIGHT CLICK

button on Wireless Remote Control Unit.

Used to move PC mouse pointer. Pointer is moved corresponding

with direction you are pressing.

This button has same function as left button in a PC mouse.

This button has same function as right button in a PC mouse. This

button is not available for controlling this projector.

Note : When your computer has no mouse

port, connect Serial Port of your

computer to Control Port of a projector

with Control Cable for Serial Port (not

supplied).

POINT button (Move pointer)

SELECT button

(left button of mouse) RIGHT CLICK button

(right button of mouse)

WARNING TEMP. Indicator flashes red when an internal temperature of a projector exceeds normal temperature. This

Indicator stops flashing when temperature of a projector returns to normal.

When WARNING TEMP. Indicator continues to flash, check items listed below.

Ventilation Slots of a projector may be blocked. In such an event, reposition a projector so that Ventilation Slots are

not obstructed.

Air Filter may be clogged with dust particles. Clean Air Filter by following section AIR FILTER CARE AND CLEANING

on next page.

If WARNING TEMP. Indicator remains on after performing above checks, Cooling Fans or Internal Circuits may be

malfunctioning. Contact service personnel from an authorized dealer or a service station.