Cisco Systems 1200 manual Installation of the WLANE-C, T Bars, Level Surface

Installation of the WLANE-C

Step 1: Unpack the box, check for all components.￿

Step 2: Make sure the Enclosure is on a level surface. Extend T-bars and adjust them to 3/4" from the bottom of the T. See figure 1. If the Enclosure is not at proper height, adjustments can be made by loosening and moving the T bars to the appropriate height.

T Bars
Figure 1	Level Surface

3/4"

Step 3: Remove one 2x2 or 2x4 ceiling tile from your ceiling grid.￿

Step 4: Make a 6" x 8" cut in the center of the selected tile. See figure 2.

Installation of the WLANE-C

Step 5: Place enclosure through the hole and make sure the T- bars are resting on the Ts. See figure 3.

		8"	T Braces
	21"	6"	21"
2'	T Bars	8"
		8"
	CeilingTile	4'

Figure 3

Step 6: The Enclosure should be about 1/4" below the tile. See figure 4.

CeilingTile
	8"
21"	6"	21"
2'	8"
	8"
	4'

Figure 2

WLANE-C Installation

6

1/4"

2'

CeilingTile

4'

Figure 4

WLANE-C Installation 7