Manuals / Brands / Computer Equipment / Computer Accessories / Cisco Systems / Computer Equipment / Computer Accessories

Cisco Systems 2600, 3600 Supported Platforms, Supported Standards, MIBs, and RFCs, Configuration Tasks

1 32

Download 32 pages, 347.19 Kb

Cisco Hoot and Holler over IP

Supported Platforms

12

Cisco IOS Release 12.1(5)T

Supported Platforms

Router Platforms:

•Cisco 2600

•Cisco 3600 series

Network Modules:

•NM-HDV

•NM-1V

•NM-2V

Supported Standards, MIBs, and RFCs

Standards

No new or modified standards are supported by this feature.

MIBs

No new or modified MIBs are supported by this feature.

To obtain lists of MIBs supported by platform and Cisco IOS release and to download MIB modules,

go to the Cisco MIB web site on Cisco Connection Online (CCO) at

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml.

RFCs

No new or modified RFCs are supported by this feature.

Configuration Tasks

See the following sections for configuring Cisco Hoot and Holler over IP:

•Configuring Multicast Routing (Required)

•Configuring the Virtual Interface (Required)

•Configuring VoIP Dial Peers (Required)

•Configuring E&M Voice Ports (Required, if used)

•Configuring for Receive Only Mode (Optional)

•Configuring Relevant Interface (Serial/Ethernet) (Required)

•Configuring Voice Ports in High-Density Voice Network Modules (Required, if using T1/E1)

Contents

Main Cisco Hoot and Holler over IP Feature Overview Current Hoot and Holler Implementations An Overview of Cisco Hoot and Holler over IP Voice Multicasting IP/TV Access Content Manager Interactive Voice Response (IVR) Migration Strategy Technical Details of the Cisco Hoot and Holler over IP Solution IP Multicast and DSP Arbitration and Mixing Bandwidth Planning Codecs cRTP, Variable-Payload Sizes and VAD Virtual Interface (Vif) Connection Trunk Benefits Related Documents Restrictions Supported Platforms Supported Standards, MIBs, and RFCs Configuration Tasks Configuring Multicast Routing (Required) Configuring the Virtual Interface (Required) Configuring VoIP Dial Peers (Required) Page Configuring E&M Voice Ports (Required, if used) Configuring for Receive Only Mode (Optional) Configuring Relevant Interface (Serial/Ethernet) (Required) Configuring Voice Ports in High-Density Voice Network Modules (Required, if using T1/E1) Configuration Examples Voice Multicasting over an Ethernet LAN Configuring the Second Router Verifying the Configuration High-Density Voice Modules Dial Peer Configuration Ethernet Configuration Voice Multicasting over a WAN Quality of Service Cisco Hoot and Holler over IP with Ethernet Topology (Two Hoot Groups) Router-1 (E&M 4-Wire Ports) Router-2 (FXS Ports) Note If you want to join the hoot and holler session directly without having to dial any session numbers, use the command connection plar, followed by the multicast-session number. Router-3 (FXO Ports) Cisco Hoot and Holler over IP with Frame-Relay Topology (One Hoot Group) Router 3 Router 2 Figure 6 Cisco Hoot and Holler over IP with Frame-Relay Topology Router 1 Router-1 Router-2 Router-3 Page Page session protocol multicast Glossary