3-7
Cisco 7204 Installation and Configuration Guide
OL-5101-02
Chapter3 Installing the Cisco 7204 Rack-Mounting the Cisco7204
Step3 If you aligned the first rack-mount bracket and cable-management bracket to the right side of the chassis,
thread two M4 x 8-mm Phillips flathead screws through both brackets and i nto the side of the ch assi s.
Use a number 2 Phillips screwdriver to tighten the screws. (Refer to Figure3-6.)
If you aligned only the first rack-mount bracket to the right side o f th e ch ass is, th re ad two M4 x 8- mm
Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips
screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount
bracket and thread two M4 x 8-mm Phillips flathead screws through t he t wo bra ckets. Use a nu mbe r 2
Phillips screwdriver to tighten the screws. (Refer to Figure3-7.)
Step4 Repeat Step 1 through Step3 for the other cable -manag ement bracket (if re quired) and rack-m ount
bracket.
This completes the procedure for installing the rack-mount a nd cab le-m ana geme nt b ra ckets on a
Cisco 7204 for a front rack-mount configuration.
Installing Brackets on the Rear of the Chassis
To install the rack-mount and cable-management brackets on a Cisco 7204 for a rear rack-mount
configuration, complete the following steps:
Step1 Locate the threaded holes in the rear sides of the chassis.
Step2 Align the first rack-mount bracket to the threaded holes in the ri ght side of t he c ha ssis.
If you want the front of the chassis protruding out of the rack, align the rack-mount bracket to the chassis
as shown in Figure 3-8. If you want the front of the chassis recessed in the rack, align the rack-mount
bracket to the chassis as shown in Figure3-9.
Figure3-8 Installing the Rack-Mount Brackets on the Rear of the Chassis so the Front
Protrudes Out of the Rack
ENABLED
MII
LINK
RJ45
FAST ETHERNET
0
0
2
4
1
3
EN
0
7
1
2
3
4
5
6
SERIAL-EIA/TIA-232
ETHERNET-10BFL
EN
RX
0
1
2
3
4
TX
RX
TX
RX
TX
RX
TX
RX
TX
H9154
Cisco 7200
SERIES
MII
EN
RJ45
EN
RJ45
LINK
1O PWR
OK
RJ-45
CPU RESET
FAST ETHERNET INPUT/OUTPUT CONTROLLER
ENABLED
PCMCIA
EJECT
SLOT 0
SLOT 1
FE MII
Rack-mount
bracket
Cable-management
bracket