Cisco Systems WET200 manual Features, Specifications

Data Sheet

wireless networks, enabling the deployment of business-quality voice over IP (VoIP) and video applications.

Additional support for VLANs, Simple Network Management Protocol (SNMP), Spanning Tree Protocol, and port mirroring make this an ideal solution for network administrators to incorporate into larger organizations.

RangeBooster technology is a compatible add-on to standard Wireless-G that nearly doubles the wireless signal range and increases throughput by up to 35 percent. Unlike ordinary wireless technologies that are hampered by signal reflections, RangeBooster devices use smart antennas and embedded processors to detect and decode reflected signals to enhance and boost data throughput. This capability also helps to reduce or eliminate “dead spots” within the wireless coverage area.

Features

●5-port 10/100 BASE-T Ethernet managed switch, autosensing half/full duplex and medium dependent interface (MDI) and MDI crossover (MDI-X)

●Supports 802.11b and 802.11g wireless connection to access point

●Easy installation and configuration via a web interface

●Supports Wired Equivalent Privacy (WEP), WPA Pre-Shared Key (WPA-PSK), WPA2-PSK, WPA-ENT, and WPA2-ENT wireless encryption

●Supports 802.1X, Extensible Authentication Protocol Transport Layer Security (EAP-TLS), and Protected EAP (PEAP) authentication with RADIUS server

●SMA detachable dipole antennas with 1x2 multiple-input, multiple-output (MIMO) to increase coverage

●Supports PoE or external DC power

●Supports SNMP and features an intuitive web-based interface

●Support 802.1Q and port-based VLAN on LAN switch - 1 VLAN bridged over wireless

●Support 802.1p, IP type of service (ToS), and differentiated services code point (DSCP) based QoS on LAN switch

●Supports rate limiting on both wired switch and wireless interface

●Supports Spanning Tree Protocol, port mirroring, and MAC-based access control lists (ACLs)

Specifications

Table 1 lists the specifications, package contents, and minimum requirements for the Cisco WET200 Wireless-G Business Ethernet Bridge.

Table 1. Specifications for the Cisco WET200 Wireless-G Business Ethernet Bridge

Specifications

Standards	IEEE 802.11g, IEEE 802.11b, IEEE 802.3, IEEE 802.3u, IEEE 802.3af (PoE), 802.1p (QoS
	priority), 802.1Q (VLAN), 802.1X (security authentication), 802.11i ready (security WPA2),
	802.11e ready (wireless QoS)
Ports	Five 10/100 BASE-T Ethernet, 12V DC power
Buttons	Reset
Cabling type	Unshielded twisted pair (UTP) Category 5
LEDs	Power, PoE, Wireless, Ethernet 1-5

© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 2 of 4