If you are using the side channel outputs of your Citation 7.0 controller, leave these channels connected directly to the side channel amplifier inputs. These channels will not be used for Dolby Digital playback of the ADP 303 digital processor. They will, however, still be used for all playback of 2 channel modes such as 6 AXIS, 70 MM, Dolby, and THX .
If your system side channel speaker locations are behind the primary listening position, you may elect to route the side channel outputs of the 7.0 processor through the ADP 303. In this scenario, the back outputs of the 7.0 processor will remain directly connected to your amplifier inputs and will not be used for Dolby Digital playback.
2. CONNECTING SUB-WOOFERS
If you are using
The ADP includes high pass filters which are engaged on the back of the unit. For most speaker configurations, switch this “speaker mode” setting to “small” on all channels. The “small” position should be used for all Citation speaker combinations.
3. CALIBRATION
The calibration of the ADP 303 is performed independently of the Citation 7.0 A/V Controller. After the
7.0is connected and calibrated, follow the instructions included with the ADP 303 for proper set up and calibration of the digital processor. The maximum output level should closely match the reference level of the 7.0 A/V Controller. We recommend the use of a SPL meter to accurately set up and match audio levels of the two units.
4. USING the ADP 303
For Dolby Digital Playback, the ADP 303 should be “ON” and the appropriate input selected on the ADP 303. Volume control is adjusted manually on the front panel of the ADP303.
When 6 AXIS or any other matrix surround mode is in use, the ADP 303 will be in a
During Dolby Digital playback, the 7.0 should be selected to the appropriate input for video switching purposes and the volume level should be set all the way down. This is necessary if both side and back channels of the 7.0 are used in the system.