2Printer Operation
Mode Settings
[Datamax Emulation]
Top Menu | Sub Menu | Default | Menu | Remarks |
| Factory Default | No | Yes | Initializes the set values of the configuration |
|
|
| No | set to the state when the unit was shipped |
|
|
|
| from the factory. |
|
|
|
|
|
| Hex Dump | No | Yes | Sets the hex dump mode. |
|
|
| No |
|
|
|
|
|
|
| Serial Monitor | – | – | Displays the state of the serial interface. |
|
|
|
|
|
| Auto Calibration | See Through | See Through | Executes the calibration of the sensor. |
| [Auto Cal] |
| Reflect |
|
|
|
|
|
|
| Sensor Monitor | See Through | See Through | Displays the level of the sensor. |
|
|
| Reflect |
|
|
|
|
|
|
Global | – | Config Set 1 | Config Set 1 | Sets the Config Set. |
configuration |
|
| Config Set 2 |
|
[Global Config] |
|
| Config Set 3 |
|
Note: To restore factory default settings, turn on printer power while pushing the MENU and PAUSE keys simultaneously, then press the FEED key and the STOP key sequentially.
40