3Printer Adjustments

Sensor Adjustments

Adjusting the Transparent sensor

1.Push the large blue-head open lever to open the head unit and sensor arm, then return only the sensor arm to its original position. Align the upper sensor marker and the bottom sensor marker (white) using the movable media guide.

Upper sensor marker

Upper sensor

Alignment of markers

 

 

Bottom sensor

Transparent sensor marker

Movable media guide

 

2.Select the transparent sensor, and open the sensor arm.

3.Install only the liner media (label backing paper) with the label media removed so that it will pass between the platen roller and the media sensor. (Be careful that media with black marks does not pass the media sensor.) Then close the sensor arm and the printhead.

Upper sensor

Label

Media gap

Liner media

Bottom sensor

4.If the PAUSE key is pressed and released while the MODE/ REPEAT key is pressed, the PRINT LED goes off, after the CONDITION LED switches from lit to rapid flashing, media feeding starts, and the sensor is automatically adjusted.

5.If automatic adjustment stops normally, the PRINT LED and CONDITION LED return to their original status. If it stops abnormally (adjustment impossible), the CONDITION LED and ERROR LED flash.

6.If the STOP key is pushed, it exits sensor adjustment mode.

40