3.4 Precautions in Installing the Printer

The printer must only be operated horizontally. Do not operate vertically or install on a wall.

Horizontal position

Vertical position

CAUTION!

DO NOT use the printer under the following conditions.

■A state subject to vibration or unstable state.

■A state with this product slanted.

•Otherwise dropping may cause injury.

•Poor print quality may occur.

■A state where this product is installed vertically or sidelong.

• Malfunction, failure, or electric shock may result.

3.5Partition for Paper Roll

At the time of shipment, this partition is set to “80-mm wide roll paper position”.

1.Confirm that the power switch is OFF.

2.Open the printer cover.

3.Set the partition to each to the slot which meets the width of the paper roll used. When using the 83-mm wide paper roll, remove the partition.

4.Change the setting of paper width by reffering to the section 5.2, "Manual Setting of Memory Switch".

60mm

Partition

80

58mm

mm

 

CAUTION!

When setting the partition to the slot for 58 mm or 60 mm paper roll, be sure not to set it slanted.

— 18 —