Clarion DB415 Preset Memory Function, Preset Scanning Preset Station Scan, Area Change

English

Preset Memory Function

Preset Memory Function can store up to 24 sta- tions: six stations for each of FM1, FM2, FM3

and AM.

Note:

•When the present memory function is used, all the content of the memory will be erased.

Manual memory function

1)Press the BND button !, and select the band you want to store in the memory.

2)Press the SRCH Left/Right button @ then select the station you want to store in the memory.

3)Press and hold the Preset button 9 for 2 seconds or longer, then the station will be stored in the memory.

Auto store function (Automatic Station Store)

1)Press the BND button !, then select the band you want to store in the memory.

2)Press and hold the AS button 8 for 2 sec- onds or longer, then the station at which the reception is the strongest will be automatical- ly stored in the memory.

Note:

•When the number of stations stored is less than six, the previous content of the memory for each direct button will be retained.

Preset Scanning (Preset Station Scan)

When the PS button 8 is pressed, the preset memory numbers flash and the stations are tuned in for 7 seconds each in the order in which they were stored. Press the PS button again to cancel the preset scanning mode.

Instant Station Recall (ISR)

With this function, a specific radio station can be recalled from any mode.

ISR memory

1)Press the FNC button 3, then select the radio mode.

2)Select the radio station which you want to store in the memory.

3)Press and hold the ISR button 4 for 2 sec- onds or longer.

Recalling ISR

Press the ISR button 4 then the display will show “ISR”, then the radio station previously memorized will be selected. Press the ISR but- ton 4 again to disengage the unit from the Recalling ISR function.

Area Change

Use this function when you are using the car stereo anywhere outside the U.S.

Switchable frequency spacing

This car stereo is initially set to tune in frequen- cy intervals of 10 kHz for AM and 200 kHz for FM, the standard calibrations in the U.S. When using the unit outside the U.S., use the following procedure to switch the frequency range.

The table below lists the frequency specifica- tions for the U.S. and other countries.

		Initial Setting	New Setting
		(U.S. standard)	(outside U.S.)
	Frequency	10 kHz	9 kHz
	spacing
AM
	Frequency	530 to	531 to
	range	1,710 kHz	1,629 kHz
	Frequency	200 kHz	50 kHz
	spacing
FM
	Frequency	87.9 to	87.5 to
	range	107.9 MHz	108 MHz

Switching the area change

Outside U.S. (New Setting)

While pressing the BND button !, press the SRCH Left button @, then “outside U.S.” will be selected.

Inside U.S. standard (Initial Setting)

While pressing the BND button !, press the SRCH Right button @, then the “U.S. standard” will be selected.

12 DB415