Regular Cab Instructions:
II.RUN WIRE HARNESS
A.Run harness to the storage tray in the rear of the vehicle behind the passenger seat.
III.ATTACH BRACKETS TO ENCLOSURE
A.Place enclosure upright so that the rippled surface is down.
B.Position brackets so that the vertical slots line up with the verti- cal set of dimples on the enclosure.
C.Attached brackets with the supplied pilot point Phillips screws, screwing through the locating dimples on the enclosure (the dimples should be centered in the vertical slots on the bracket).
IV. TEST THE ENCLOSURE
A.Place enclosure into the vehicle, the subwoofer will fire down (the correct position of the enclosure is underneath the rear folding seat on the drivers side).
B.Plug in the wire harness to the enclosure (ground the 8" black wire on the wire harness).
C.Plug in the “T” harness behind the radio (or hard wire the supplied “pigtail” harness to the factory wiring).
D.Test for proper operation.
E.Adjust subwoofer gain (gain pod is located on the amplifier next to the wire harness connector, and is adjustable with a Phillips screw driver).
V.ATTACH THE ENCLOSURE TO THE VEHICLE
A.Screw in the brackets to the back of the storage tray using the supplied 1"
VI. REASSEMBLE THE VEHICLE
A. Make sure all the wires are hidden. Then do the process in reverse order.
Clarion Corporation of America
661 West Redondo Beach Blvd Gardena, CA 90247
10 - PSWDRAM Rev. 1 (04/00) | 4 |
|
