ENGLISH EN
How To Operate The Machine (cont)
How To Clean A Floor
WARNING: Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surfaces. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.
To clean a floor follow this procedure:
1.Set the parking brake (if equipped with machine.)
2.Put the water and a cleaning chemical in the clean solution tank.
3.Release the parking brake (if equipped with machine.)
4.Turn the key switch "ON".
5.Lower the squeegee.
6.Put the brush switch in the down position.
7.Turn the solution knob to the right to activate the flow of solution. Adjust the flow of clean solution to the flow desired.
8.Move the machine across the floor in the forward direction.
9.Make a 180° turn.
NOTE: When you make more passes across the floor, let the brush clean approximately 2 inches (5 cm) of the area already cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove the solution in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1.Apply solution to the floor.
2.Do not lower the squeegee. This will keep the vacuum motor off.
3.Lower the brush or pad and scrub the floor.
4.Scrub the floor again with additional solution and lower the squeegee.
5.Pick up all the solution with the squeegee.
Clarke® Operator's Manual (EN) - BOOST 28 |