EN
Procedures For Transporting (cont.)
11.Fasten the machine to the vehicle. Clarke recommends a strap over the top of the machine and a strap to keep the machine from rolling forward or backwards. If this is not done, there is a possibility of the machine toppling over. Three tie down points are provided on the steel frame of the machine, for securing machine (see figure 2a).
How to Remove the Machine From a Van or Truck
1.Make sure there are no obstructions in the area.
2.Make sure the unloading ramp is at least eight
(8) feet (2.5m) long and a minimum of 32"
(0.8m) wide, and strong enough to support the machine.
3.Make sure the ramp is clean and dry.
4.Put the ramp in position.
5.Unfasten the machine.
WARNING: The machine is heavy. Make sure you use two able persons to assist in moving the machine down the ramp.
6.On S17/S20 models, get two people to pull machine off ramp. It is recommended that the "S" model be unloaded in the forward position.
7.On the L17/L20 models only, turn the key switch "ON" and press the green "ON" button.
8.Set the traverse center knob to the slowest forward speed setting. Carefully and slowly, drive the machine to the top of the ramp and start down (L17/L20 models only).
9.While pushing in the right or left forward switch the machine will go forward (L17/L20 models only). See figure 2.
10.As the machine begins to travel down the ramp, push in the forward switch to maintain a slow downward speed (L17/L20 models only).
11.Replace squeegee assembly, brush housing, and brush or pad driver after machine is unloaded and ready to use.
Figure #2
Tie Down Point (both sides of
machine)
Tie Down Point
Figure #2a
Page | Clarke® Operator's Manual |