Procedures For Transporting
How to Put the Machine Into a Van or Truck
WARNING: | This machine is heavy. Get |
|
| assistance before attempting |
|
| to transport or move it. Use |
|
| two able persons to move the |
|
| machine on a ramp or |
|
| incline. Always move slowly. |
|
| Do not turn the machine on a |
|
| ramp. Do not stop and leave |
|
| the machine on a ramp or |
|
| incline. The loading ramp |
|
| must be a minimum of 32" |
|
| wide. |
|
WARNING: | Machines can topple over if | Figure #1 |
| ||
| guided over the edges of |
|
| stairs or loading docks and |
|
| cause injury or damage. |
|
| Stop and leave this machine |
|
| only on a level surface. |
|
| When you stop the machine, |
|
| put all switches into their |
|
| "OFF" position. |
|
1.Make sure the loading ramp is at least eight
(8) feet (2.5m) long and a minimum of 32" (0.8m) wide, and strong enough to support the machine.
2.Make sure the ramp is clean and dry.
3.Put the ramp in position.
4.Remove squeegee assembly, brush housing and brush or pad driver before loading. Clarke recommends that both the solution tank and recovery tank are empty before loading.
5.Turn key switch "ON" (on L30 model only).
6.Align the machine on a level surface five (5) feet (2 m) in front of the ramp.
7.Put the traverse knob at full speed (on L30 model only).
8.For the L30 machine, push in either one of the forward/reverse switches while pushing in the white reverse switch. Back the machine up the ramp. See figure 1.
9.For the S30 machine, push the machine back- wards to the top of the ramp.
10. Turn the key switch "OFF".
Page | Clarke® Operator's Manual |