INTRODUCTION

THANK YOU

Thank you for purchasing the Classen Model SC-20, SC-18, or SC-12 sod cutter.

READ THIS MANUAL

Read this manual carefully to learn how to operate sod cutter correctly. Failure to do so could result in personal injury or equipment damage.

This manual should be considered a permanent part of your sod cutter and should remain with it if you sell it.

WARRANTY

Refer to back page.

MEASUREMENTS

U.S. units of measure are used in this manual.

SERIAL NUMBERS

Write frame and engine serial numbers, plus model numbers in "Owners Record" section below. Your dealer needs these numbers when you order parts. The serial number is located on a sticker on the center section of the frame.

DIRECTIONS

"Right Hand" and "Left Hand" sides of the sod cutter are determined by facing the back of the sod cutter as you would operate the machine.

OWNER’S RECORD

DATE PURCHASED _________________________________

SOD CUTTER MODEL NUMBER______________________

SOD CUTTER SERIAL NUMBER______________________

ENGINE MODEL NUMBER __________________________

ENGINE SERIAL NUMBER___________________________

PRE-DELIVERY CHECK LIST

Check the following before you deliver the sod cutter to the customer.

1.Guards and shields fastened in place.

2.Decals fastened and legible.

3.Tire pressure.

4.Gas lever on engine turned on.

5.All eight lubrication points greased.

6.2:1 gearbox oil level.

7.Engine oil level.

8.Air cleaner.

9.Touch up scratches.

10.Chain tight.

11.Engine belt tight.

12.Levers working properly.

13.All controls.

14.Add fuel, start engine, test run.

DATE SET UP __________/__________/__________

DELIVERY CHECK LIST

Review the operators manual with the customer. Explain the following:

1.Classen Mfg., Inc. warranty.

2.Safe operation and service.

3.How to use controls.

4.Operating the machine correctly.

5.Transporting the sod cutter.

6.Correct fuel and lubricants.

7.Daily and periodic inspections.

8.Changing oil after break-in period.

9.Servicing the sod cutter regularly and correctly.

10.Classen Mfg., Inc. parts and service.

11.Give the customer the operators manual and encourage customer to read it.

DATE DELIVERED __________/__________/__________

SIGNATURE _______________________________________

1

Page 3
Image 3
Classen SC-12/8.0, SC-20/5.5, SC-12/5.5 manual Introduction, OWNER’S Record, PRE-DELIVERY Check List, Delivery Check List