Closet Maid 1775 specifications 12” 30,5 cm, 16” 40,6 cm, 01-84617

1775

1

Use one support bracket 2-3” from each end of shelf and one every 36” in between. Position support bracket on shelf as shown. Note proper position for various shelf types.

Coloque un soporte entre 5 cm y 7,6 cm desde cada extremo de la repisa y a cada 91,4 cm entre medio. Ponga el soporte en la repisa tal como se muestra. Tome nota de la posición correcta para los diversos tipos de repisas.

12” (30,5 cm)	12” (30,5 cm)	16” (40,6 cm)	16” (40,6 cm)
Shelf & Rod	SuperSlide®	Shelf & Rod	SuperSlide®
			with Hang Rod

2

Level shelf. Drill 1/4” hole through wall using support bracket as guide. DO NOT PUNCH HOLES.

Nivele la repisa. Perfore un agujero de 6 mm a través de la pared usando el soporte como guía. USE TALADRO SOLAMENTE.

3

Push pre-loaded anchor through support bracket and into drilled hole. Use bottom of hammer handle to push in pin. For removal, pry pin out with screwdriver.

Empuje el tarugo precargado por el soporte en el agujero preforado. Use la parte inferior del mango del martillo para empujar la clavija hacia adentro. Para remover, palanquee la clavija sacándola conun destornillador.

If a ClosetMaid® product does not give user complete

satisfaction when installed in accordance with manufacturer's instructions, it will be exchanged free of charge. Only the unsatis-

factory	part	in	a	multi-piece	product
will be exchanged.

Consumer Toll-Free Help Line 1-800-874-0008

(U.S.A and Canada)

Manufacturer reserves the right to change specifications without notice.

Made in USA

©ClosetMaid Corporation 2005

Ocala, FL 34478-4400

01-84617

0 75381 01775 6