6"
"
4. INSTALLATION PROCEDURES A. Connect the 1/4”OD tubing between water inlet of chiller and the supply water hose with pressure
rating suitable for use with the application. The tubing must be acceptable for use with potable
water.
B. Using the 1/4”OD tubing included with the (gooseneck) faucet, connect on water outlet of chiller.
-Flush water in lines before installing gooseneck faucet.
-Acceptable supply water pressure is 15~100 PSI (100~700kPa)
CAUTION: TO PR EVENT PRO PERTY DAMA GE DUE TO WATER LEAK AGE, SEEK INSPECTI ON BY
PLUMBERS TO SEE THE WATER PRESSURE IS LESS THAN 100PSI (690KPA) BEFO RE YOU CONNECT
THE SUPPLY WATER HOSE.
C. Slowly open supply water valve. By opening faucet lever, let water flows for about one minute.
Check all the connections.
-Purge off all air from all water lines by opening faucet lever. Steady stream assures all air is
ventilated.
D. Prior to drinking, flush water through chiller for at least 5 minutes.
E. Check the available power supply against the chiller data plate to assure correct electrical service.
F. Plug in chiller and the chiller will be ready to serve you cold water in 30 minute after installation
CAUTION: FAILURE TO ABID E BY ABOVE PROCEDURE CAN CAUSE PHYSICAL D AMAGE ON THE
COOLER.
5. STORAGE A. Unplug power cord.
B. Open faucet until water is room temperature.
C. Close the source water valve.
D. Disconnect the water pipe from the product.
E. Place a bucket beneath the drain pipe. Open the drain cover and cap. Then, drain the remaining
water.
F. When storing, ensure it stands on its erect position on the flat and even ground. (Do not lay the
product on its sides down or upside down.)
G. When not use for a long period of time, conduct product cleaning before you put in storage.
CAUTION: FAILURE TO ABIDE BY ABOV E PROCEDURE MAY INCUR PHYSICAL DAMAGE ON THE
COOLER.
7. TROUBLESHOOTING GUIDE