Operation
Mode Functions
Introduction | Operation | Customer Assistance Warranty |
Set DCS Privacy Codes | • |
|
Mode Button | To select a DCS privacy code: | |
| 1. After selecting a channel, press the Mode | |
| button until the DCS icon appears and the | |
| small numbers flash on the display | |
| (01 through 104). | |
DCS Privacy Code | NOTE | |
| ||
| If CTCSS is turned on at the channel | |
| selected, the display will flash the | |
| DCS icon and “OFF.” To switch from | |
Channel Buttons | CTCSS to DCS, press the Channel Up | |
or Channel Down button while the | ||
| ||
| display is flashing “OFF.” The display | |
| will then show the small numbers | |
| flashing and you will then be able | |
| to proceed to step 2. |
2.Press the Channel Up or Channel Down button to select a DCS privacy code. You can hold the Channel Up or Channel Down button for fast advance.
3.When your desired DCS privacy code is displayed, choose one of the following:
a.Press the Mode button to enter the new setting and proceed to other functions.
b.Press the Lock/Enter button to enter the new setting and return to Standby mode.
c.Do not press any buttons for 15 seconds to enter the new setting and return to Standby mode.
You can use your microTALK® radio to listen to NOAA All Hazards • Radio channels transmitting in your area.
To listen to All Hazards Radio channels:
1. Press the Mode button until the WX (All Hazards Radio) icon, the currently selected All Hazards Radio channel, and signal strength are displayed.
2. Use the Channel Up or Channel Down button to change All Hazards Radio channels.
3. WX (All Hazards Radio) icon will continue to be displayed when All Hazards Radio is on. Choose one of the following:
a. Press the Mode button to proceed to other functions.
b. Press the Lock/Enter button to exit All Hazards Radio channels mode and return to Standby mode.
*National Oceanographic and Atmospheric Adminstration
10 | 11 |
