Nothing comes close to a Cobra®
Advanced Operation
47
ScanDuring Scan,the radio will rapidly switch from channel
to channel through all the channels. Whenever any activity
is detected, the radio will stop the scan for ten (10) seconds
to allow you to listen briefly on that channel. It will then
continue to scan unless you switch out of the Scanmode.
NOTE
The radio must be squelched for Scan mode to
function. See page 36 for squelch procedure.
To Enter Scan:
1. From Standby mode, press the Scan button.
The radio will immediately begin to scan the entire channel
map selected in the active channel map. SCAN will show
on the LCD.
To Exit Scan:
1. From Scan mode, press the Scan button.
This will return the radio to Standbymode on the last
scanned channel.
During Scan (while receiving an incoming transmission),
You Can Choose From The Following:
a. Press the Talkbutton to remain on that channel and end
scanning. This will return the radio to Standbymode.
b. Press the Up/Downbuttons to resume scanning.
If you do not press any buttons within ten (10) seconds,
your radio will automatically resume scanning.
During Scan (while not receiving a transmission):
a. Press the Talkbutton to communicate on the last
channel scanned and return to Standbymode.
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Caution Warning
Installation Customer
Assistance
Operating Your Radio
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation Customer
Assistance
Scan Button
Scan
88
14
88 30
60
75
79
A
68 69
71
72
78
A
88
15
30
60
75
Scanning
46 English
Advanced Operation
Dual-WatchDual-Watchgives you one (1) button access to scan the two (2) locations of most
importance to you. Channel 16 will always be included as a scanned location. The
remaining location will be the VHF channel in effect when you enter Dual-Watchmode.
NOTE
The radio must be squelched for dual-watch to function. See page 36
for squelch procedure.
To Enter Dual-Watch Mode:
1. In Standby mode, use the Up/Down buttons to go
to the channel you want to add as the second location
to be scanned.
2. Press the Dual-Watchbutton.
Dual-watchwill be indicated on the LCD and the radio
will scan between Channel 16 and the second dual-watch
location you selected. A signal on any one (1) of the two (2)
channels will stop the scan to allow youto li sten to the traffic
on the channel. The channel number will be displayed on
the LCD.
To Exit Dual-Watch Mode:
1. Press the Dual-Watchbutton. The radio will
return to Standbymode.
During Dual-Watch (while receiving an incoming
transmission), You Can Choose From The Following:
a. Press the Talkbutton to remain on that
dual-watchlocation and return to Standby mode.
b. Press the Up/Downbuttons to resume scanning
dual-watchlocations.
If you do not press any buttons, your radio will
automatically resume scanningdual-watch locations
when the incoming transmission is complete.
During Dual-Watch (while not receiving a transmission):
a. Press the Talkbutton to communicate on the last
dual-watch location scanned and return to Standby mode.
Intro Operation Customer
Assistance
Warranty
Notice
Secondary Icons
Caution Warning
Installation Customer
Assistance
Operating Your Radio
Dual-Watch Button
Intro Operation Customer
Assistance
Warranty
Notice
condary Icons
Caution Warning
Installation Customer
Assistance
Standby Mode
Dual-Watch Mode