Cobra Electronics MT 525 manual Battery Installation, Radio Power

OPERATION		English
Battery Installation	Remove Belt Clip Lock Tab	Insert Batteries

To Install or Replace Batteries:

1. Remove belt clip by releasing belt clip latch and sliding clip Up.

2. Pull down on the BATTERY DOOR LOCK TAB to remove the battery compartment cover.

3.Insert four (4) AAA batteries. (Always use high-quality alkaline batteries.) Position batteries according to polarity markings.

4.Replace Battery Compartment cover and belt clip.

NOTE: See “Optional Accessories” for accessory availability and ordering instructions.

Battery Charging

Charge Tab Charging Batteries

When the optional NiMH battery pack (part No. FA-BP) is used, the batteries can be charged using the optional rapid wall mount charger (part No. PA-CW). Simply place the battery pack in the battery compartment, open the CHARGE TAB on the side of the unit and insert the

plug into the charge jack to start charging. The batteries should be fully charged in about three (3) hours. WARNING: Only the NiMH battery pack FA-BP can be recharged.

NOTE: See “Optional Accessories” for accessory availability and ordering instructions.

Radio Power Power Button

To Turn Your Radio On:

1. Press and hold the POWER button until you hear a series of audible tones indicating that the radio is On.

Your microTALK® radio is now in LISTENING MODE, ready to receive transmissions. The radio is always in LISTENING MODE, except when the TALK, CALL or MODE/LOCK buttons are pressed.

To Turn Your Radio Off:

1. Press and hold the POWER button.