Cobra Electronics PR 1050 WX Programming Memory, Locations, Using the Scan Function

MODE ENTER button button

TALK button

O P E R AT I O N ENGLISH

ENGLISH O P E R AT I O N

Programming Memory

5. Press the MODE

Recalling Memory Locations To scan main channels:

Locations

Your microTALK® radio has 10 memory locations (1-10) for storing your most frequently used channels and privacy codes. To program locations:

1. Push the MODE
button until the	MODE
Memory icon and
	button
the memory
location flashes.

2. Select the memory	CHANNEL SELECT
location you wish
	button
to change by
pushing the
CHANNEL SELECT

button up or down. (NOTE: You must press the channel button before programming a memory location.)

3.Press and release the MODE button again. The Memory icon and the main channel number will flash.

4.Select the main channel you wish to store by pushing the CHANNEL SELECT button up or down.

button again to store the main channel in memory and move to

privacy code selection. The privacy code number begins flashing and the Memory icon continues to flash.

6.Select the privacy code (00-38) you wish to store by pushing the CHANNEL SELECT button up or down.

7. Press the ENTER button to program

your selection. You may also press the

TALK button to

transmit your selected channel and privacy code, which will be stored into the memory location you are using. (NOTE: To “unprogram” a memory location you programmed previously, select 00 for both the main channel and privacy code in steps 4 through 6.)

8.Press and release the ENTER button to return to Standby mode at your new memory location, or press and release

the MODE button to save the memory location and proceed to other functions.

To recall a channel you have stored in a memory location:

1. Press the MODE
button until the	MODE
Memory icon and
a memory	button
location flashes.

2.Select your

desired memory	CHANNEL SELECT
location by	button
pushing the
CHANNEL SELECT
button up or
down. Press the	ENTER
ENTER button	button
to select your
memory location
channel. You will

now be in Standby Mode on that channel.

3.Repeat steps 1 and 2 to recall other memory locations.

Using the Scan Function

Your microTALK® radio can automatically scan main channels (1-22), the privacy codes (00-38) within one main channel, or memory locations.

1.Press the MODE button until the Scan icon and main channel number flashes.

2.Push the CHANNEL SELECT button up or down and the unit will begin scanning the main channels. (NOTE: The unit “ignores” privacy codes while scanning main channels.)

3.The radio will continue to scan all main channels and stop if an incoming transmission is detected. The unit will remain on that channel for 10 seconds. During that time you can:

a)Press and hold

the TALK button	TALK button
and talk. The radio
will remain on that
channel and return
to Standby mode.

b)Push the CHANNEL SELECT button up or down to resume scanning main channels.

c)Press the MODE button to proceed to privacy code scanning (see following page).

If you do not press any button within 10 seconds, the radio will automatically resume scanning main channels.

9 10