CHARGING AND USE OF RECHARGEABLE BATTERIES

Rechargeable Battery Operation

This unit can fully recharge the specified rechargeable battery, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be charged before they are used for the first time, if they have not been used for a long period (over 60 days).

1.Open the battery compartment cover and insert two of the recommended recharge- able batteries, matching polarity. (1.2V

600mA)

BOTH BATTERIES MUST BE OF THE

RECHARGEABLE NICKEL-CADMIUM

TYPE, OTHERWISE THE BATTERIES

MAY EXPLODE OR LEAK.

2.Plug in the AC adaptor and set the Charge Switch to ON position to start charging.

USE ONLY THE AC ADAPTOR SUPPLIED

WITH THE SET FOR CHARGING.

Note: Charge indicator will illuminate.

3. After 15 hours, please unplug the AC adaptor and switch the Charge Switch to the OFF position.

DO NOT CHARGE CONTINUOUSLY FOR 24 HOURS OR MORE. DOING SO CAN CAUSE THE PERFORMANCE OF THE R E C H A R G E A B L E B AT T E R Y T O DETERIORATE.

4.If the operating time decreases drastically even when the rechargeable nickel- cadmium batteries are properly recharged, purchase a new set of rechargeable nickel-cadmium batteries.

5.When charging for the first time or after a long time, playing time may be reduced. In this case, charge and discharge the batteries several times.

4

MAINTENANCE

Cleaning the Cabinet

Wipe with a soft cloth. If the cabinet is very dirty, dampen the cloth with a weak solution of neutral detergent and water, and then wipe clean.

Cleaning the Lens

A dirty lens will cause sound skipping and, if the lens is very dirty, the CD may not work. Open the disc cover and clean the lens as below.

Dust or Dry Particles

Using a camera lens brush/blower, blow on the lens a couple of times, then wipe it lightly with the brush to remove dust. Then, blow on the lens once more.

Fingerprints

If the lens cannot be cleaned by using a brush/ blower, use a dry cotton swab starting in the middle and working to the outside edge.

HANDLING COMPACT DISCS

 

 

This unit is designed to play only compact disc bearing the

 

identification logo below. Other disc may not conform to the CD

 

standard and may not play properly.

INSERT WITH￿

PRESS THE CLAWS￿

• Dirty, scratched or warped disc may cause

THE LABEL￿

AT THE CENTER OF￿

FACING UP.

THE DISC CASE.

skipping or noise.

 

 

 

• Handle the disc only by the edges. To keep

 

 

clean, do not touch its surface.

PRESS THE￿

LIFT OUT WITHOUT￿

DISC GENTLY￿

TOUCHING THE ￿

• Discs should be stored in their cases after use

TO INSERT IT.

RECORDED SURFACE.

 

 

to avoid serious scratches.

 

 

• Do not expose disc to direct sunlight, high

 

 

humidity, high temperatures or dust etc. Pro-

INCORRECT

 

 

 

longed exposure to extreme temperatures can

 

 

warp the disc.

CORRECT

INCORRECT

• Do not stick or write anything on either side of

 

 

disc. Sharp writing instruments, or the inks used

 

 

in some felttip pens, may damage its surface.

FROM THE CENTER TO THE EDGE

 

 

 

Remove the disc

Hold the edge and gently press the centre pivot as illustrated, to pick up the disc.

CAUTION:

Wait for the disc to stop rotating before pressing the OPEN button.

Note: This unit can play 3" (8cm) single CD's without an adaptor. Do not use a CD single adaptor for these discs.

5

Page 3
Image 3
COBY electronic MPCD900 instruction manual Charging and USE of Rechargeable Batteries, Maintenance, Handling Compact Discs