Chapter 3: Setting up the Printer14
A798 Thermal Receipt Printer: User Guide A798-UG00001 Rev. A 10/07 10/07 A798-UG00001 Rev. A A798 Thermal Receipt Printer: User Guide
A798 Thermal Receipt Printer: User Guide A798-UG00001 Rev. A 10/07 10/07 A798-UG00001 Rev. A A798 Thermal Receipt Printer: User Guide
1 Select a location that allows adequate support for
the power supply and reaches an electrical outlet and
the printer. Mount the bracket using the instructions
provided with the A798 power supply wall-mount kit.
2 Set the power supply (K301, available separately) onto
the bracket and secure with the provided tie wrap.
Caution: Do not plug in the power supply until all the
cables are connected, as this may damage the
printer. (See next section page 15.)
Spill shield option installationTop and bottom spill shields provide added protection for your printer from moisture or spills. The following instructions
describe how to install both of these shields. Shields may be installed individually or as a set.
Tools: Phillips head screwdriver
To install the top spill shield:
1 Clean the printer receipt cover in the area where the top spill cover is to be installed.
2 Remove receipt cover and drill holes using a #5/32 or 4 mm drill bit (as shown). Open holes further by drilling with a
5/16 or 8 mm drill bit.
3 Position the spill shield to the printer.
4 Fasten spill shield to receipt cover with screws and washers provided.
Power
Supply
Bracket
Ty-Wrap
Cord
Power
Supply
Ty-Wrap
Bracket Cord
Screws &
Anchors
2
Drill 5/16” hole
1