3 Attach Tent to Frame Using Frame Clips

–Attach frame clips along the edges of tent to frame poles. (illus. 5), (illus. 6)

–Make any adjustments to the tent corner stakes that are needed.

NOTE:

 

Grommets

 

for rainfly

 

pole are on

 

frame clip

illus. 5

webbing

Frame clips

illus. 6

Assembled tent without rainfly.

4 Attach Rainfly

–Assemble rainfly poles by interlocking shock-corded poles.

–Insert the first rainfly pole through pole sleeve at the front center of the curved edges of the underside of rainfly. The second pole goes in back. (illus. 7), (illus. 8)

–Drape rainfly over tent frame, pole side down. One rainfly pole should be over the door and the other pole over the rear window.

–Connect the six elastic loops with hooks (found at the rainfly corners) to the rings located at the end of the stake loops. (illus. 8) –Insert the tips of the rainfly poles into the grommets on the pole sleeve webbing. (See above illus. 6) –Secure rainfly with attachments

located on underside of fly. (illus. 8) –Attach and stake out guylines. (illus. 8)

illus. 7 Insert rainfly poles through the

2 pole sleeves on underside of rainfly

Rainfly pole in grommet

Guylines

illus. 8

Completed tent with rainfly.

Rainfly pole through

pole sleeves

Underside of rainfly attaches to frame poles

Rainfly hooks attach to fabric loops on the corner frame clips

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN SRI LANKA Rev. 12/05

Do not leave your tent set-up for weeks at a time, be aware that expo- sure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammabili- ty requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign sub- stance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN SRI LANKA

Page 2
Image 2
Coleman 10 18'x10 manual Attach Rainfly, Attach Tent to Frame Using Frame Clips, Illus Completed tent with rainfly