CIQALATM TENT 12’ X 10’
Before you begin
Read all instructions before set up.
•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees.
•For best results in windy conditions, position end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
MODEL 20000 011 09
Parts and Components
Description | Part Number |
Main Poles, Long, Black (2) | 5010000386 |
Ridge Pole, Gray (1) | 5010000387 |
Back Awning Pole w/Metal Tips, Black (1) | 5010000388 |
Front Awning Pole, Long, Black (1) | 5010000389 |
Rainfly | 5010000400 |
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction.
2. Assemble the interlocking
3. Insert both, long, black poles through sleeves in top front and center locations on tent as shown. (Fig. 1)
4. Insert the gray ridge pole through sleeve on top of tent that runs from front to back. (Fig. 1)
Long, Black,
Main Poles
Gray,
Door (Front of Tent) | Fig. 1 |
|
|
STITCH LINE
5. | Insert metal tip on gray ridge pole into metal | Gray Ridge Pole in Front & |
| grommet located at front of tent. (Fig. 2) | Back Metal Grommets |
6. | Insert one end of front and center black poles |
|
| into pins in front corner and side of tent. |
|
| (Fig. 3 & 3A) |
|
7. | Go to opposite end of each pole and gradually | 3B |
| apply pressure to the poles forming arches. | Fig. 2 |
| Insert the pin into the pole end at the front |
|
| corner and side of tent. (Fig. 3) |
|
8. | Go to back of tent and gradually apply pressure on | 3A |
| the gray ridge pole forming an arch; then insert metal | |
| tip of pole into metal grommet om web strap at |
|
| back of tent. (Fig. 3) |
|
9. | Stretch corners and sides of tent until floor is |
|
| taut then hammer stakes through loops to secure. |
|
| (Fig. 3B) | Fig. 3 |
|
|
To Attach Rainfly
1.Assemble long, thin, black interlocking
2.Unfold rainfly. Locate the sleeve, along front edge, and the hook & loop fasteners on the underside of rainfly.
3.Drape rainfly over tent. Make sure the sleeve is centered over the door and the hook & loop fasteners, on the underside of the rain- fly, are positioned over the black main poles and gray pole. (Fig. 4)
4.Slide front awning pole through sleeve at front of the rainfly. (Fig. 4)
5.Insert one end of front awning pole into pin in front corner of tent. (Fig. 5A)
6.Go to opposite end of front awning pole and gradually apply pressure until pole forms an arch. Insert the pin into the pole end at the front corner of tent (Fig. 5 & 5B). Drive stakes through straps on vestibule flap. (Fig. 5C)
(continued on other side)
| Sleeve on Front | |
| of Rainfly | |
Door | Front Awning | |
Pole | ||
| ||
| Fig. 4 |
Vestibule Flap
Fig. 5
5C
5A
5B
