3 Raise Screen Room

–Assemble all chain shock-corded Roof Pole. When assembled will

form a continuous arch with both ends pointing down. (illus. 6)

–Insert square end of upright poles into curved roof poles and raise tent upright. (illus. 7 & 8)

–Angle screen room upright pole back toward tent body and insert pin of pin & ring system into end of pole.

–Repeat for second pole. (illus 7)

Screen ridge pole sleeve

Forms an arch

Illus. 6 Curved Roof

Pole assembly.

Brace Pole

Curved

poles in

pole sleeve

illus. 8

Curved ridge pole

attaches to upright pole

illus. 7 Tent shown

without rainfly

Pole ties

Frame ties

4 Attach Rainfly

–Assemble rainfly pole by interlocking shock-corded pole.

–Insert rainfly pole into reinforced pockets located at the center edges of the underside of rainfly. (illus. 9 & 10)

–Tie underside of rainfly to the rainfly pole with pole ties. (illus. 9)

–Drape rainfly over tent frame, pole side down. Rainfly pole should point out over screen room and rear window of tent.

–Connect the eight elastic loops with “S” hooks, (found at the rainfly corners) to the eight rings located at the end of the stake loops at the corners of the tent.

–Secure rainfly with frame ties

located on underside of rainfly. (illus. 11) –Stake out tent with four side

guylines. (illus. 11)

illus. 9 Insert Rainfly Pole piece into pocket on underside of Rainfly

Underside frame ties attach to tent poles

illus. 11 Tent shown completed.

illus. 10

Underside of rainfly shown with pole inserted into pole pockets

Guylines

Pin inserted into

screen room upright pole

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspira- tion, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

Seam sealer has not been provided with your tent. It is necessary and we recommend seam sealing your tent prior to camping. Seam

sealer may be purchased through your local retailer or at your local sporting goods store.

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage nylon material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flamma- bility requirements of CPAI-84.The fabric will burn left in continuous contact with any flame source.The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

PRINTED IN SRI LANKA Rev. 11/00

MADE IN SRI LANKA

Page 2
Image 2
Coleman 16'X13 owner manual Raise Screen Room, Guylines Pin inserted into Screen room upright pole