Coleman 16'x7 manual Raise Ends of Tent, Attach Rainfly, Made In China

Models: 16'x7

1 2
Download 2 pages 43.28 Kb
Page 2
Image 2
Raise Ends of Tent
illus. 9
Completed tent with rainfly.
illus. 8

Raise Ends of Tent

illus. 6 Assembled tent

3

– Insert grey shorter shock-corded poles through pole sleeves marked with grey binding at both ends of tent above windows.

– Insert second pin (located near center of tent) of pin & ring system into pole end.

– Go to opposite end of pole and gradually apply pressure to the pole forming an arch until you are able to insert the pin into the pole end.

– Attach frame clips. (illus. 5)

without rainfly.

Grey poles

Grommets for rainfly poles

illus. 5

Frame clips

4 Attach Rainfly

– Assemble rainfly poles by interlocking shock-corded pole.

– Insert rainfly pole into pole sleeves located at the center edges of the underside of rainfly. (illus. 7), (illus. 8)

– Drape rainfly over tent, pole side down. The rainfly poles should cover

the door and rear window of tent.

– Insert rainfly poles into grommets on tent body. (illus. 6)

– Secure rainfly with attachments located on underside of rainfly.

– Connect the elastic loops with “S” hooks (found at the rainfly corners) to fabric loops near

frame clips. (illus. 8)

– Stake out all guylines. (illus. 10)

illus. 7 Insert rainfly pole through pole sleeve on underside of rainfly.

End guylines

4 Attach Rainfly Stake down doormat

illus. 10

Stake out the tent with adjustable guylines.

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

PRINTED IN CHINA Rev. 9/07

MADE IN CHINA

Page 2
Image 2
Coleman 16'x7 manual Raise Ends of Tent, Attach Rainfly, Made In China