EVANSTONTM 14’ X 12’ MODEL 2000000144
STITCH LINE
Before you begin
Read all instructions before set up.
•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees.
•For best results in windy conditions, position end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
Parts and Components
Description | Part Number |
Main Poles (2) | |
Side Poles (2) | |
Rainfly | 5010000505 |
Vertical Hinge Door Pole, Black, short with |
|
plastic cap tips (1) | |
Hinge Door Pole, Black, long with |
|
plastic cap tips (1) |
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. Unzip door.
2. Assemble main tent poles by interlocking both longer, black
3. Insert black poles through sleeves in top of tent forming an “X” as shown. (Fig. 1)
Fig. 1
4.Insert one end of each black pole into pins in rear corners of tent. (Fig. 2)
Fig. 2
5.Go to opposite end of each pole and gradually apply pressure to the pole forming an arch. Insert the pin into the pole end at the tent corners.
(Fig. 3)
6.Stretch corners of tent until floor is taut then hammer stakes through loops to secure.
Fig. 3
7.Attach frame clips along edges of tent to frame poles (Fig. 4)
Fig. 4
To Set Up Tent (continued)
8.Assemble the interlocking
9.Slide pole through sleeve on front of
tent. (Fig. 5) | Fig. 5 |
|
10.Pull down on pole and insert into center pin location on side of tent. (Fig. 6)
11.Go to opposite side of tent and gradually apply
pressure to the pole to
form an arch. Insert the Fig. 6 pin into the pole.
12.Attach frame clips along edges of tent to frame poles. (Fig. 7)
Fig. 7
To Attach Rainfly
1.Assemble remaining interlocking
2.Drape rainfly over tent. Make sure end with two flaps is centered over the door.
3.Slide gray pole through sleeve in
rainfly. (Fig. 8) | Fig. 8 |
|
4.Insert one end of each rainfly pole into remaining pin in front corner of tent. Gradually apply pressure to other end of pole to form an arch & insert into other front pin. (Fig. 9)
Fig. 9
5.Hook clips on elastic loops of rainfly onto rings on all four corners of the tent. (Fig. 10)
Fig. 10
6.Secure rainfly with velcro hook & loop ties located on underside of fly. (Fig. 11 & 12)
Fig. 11 |
| Fig. 12 |
|
|
|
