Coleman 2000000437 manual Before you begin, Parts and Components, To Set Up Tent

HELIOSTM X3

MODEL 2000000437

Before you begin

Read all instructions before set up.

•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

•Do not set up your tent under trees.

•For best results in windy conditions, position end of tent into the wind.

•Enlist the help of at least one other person to assist you when it is time to assemble the tent.

Parts and Components

Description	Part Number
Main Poles, Red (2)	5010000521
Cross Poles, Silver (2)	5010000523
Vestibule Poles, Gold (2)	5010000522
Rainfly, Orange	5010000525

STITCH LINE

To Set Up Tent

1.Unfold tent and spread out on a clean, level surface with the doors facing the desired direction. (Fig. 1)

2.Stretch corners of tent until floor is

taut then hammer stakes through loops on web straps to secure. (Fig. 1A )

3. Assemble two red main poles and two silver cross poles by interlocking the shock-corded poles.

4. Insert red main poles through sleeves with red trim in top of tent forming an “X” as shown. (Fig. 1)

5. Insert silver cross poles through sleeves with silver trim in top of tent. NOTE: Make sure the silver

poles pass through the cutouts in the red trimmed sleeves and under the red main poles. (Fig. 1 & 1B)

	Red Trim on Sleeve		Fig. 1
		1B
		Cutout in Red Sleeve
			Silver
Red, Shock-corded	Door	Cross Pole
Main Poles		Door

Silver Trim on Sleeve

Silver, Shock-corded

Cross Poles

1A

6.Insert one end of red main pole into first grommet in web straps at front corner of tent.

(Fig. 2 & 2A)

7.Go to opposite end of red main pole and gradually apply pressure to the pole forming an arch. Insert the end of pole into first grommet at the back corner of tent. (Fig. 2 & 2A)

8.Repeat for second red main pole.

9.Insert one end of silver cross pole into grommet in web strap at side of tent. (Fig. 2 & 2B)

10.Go to opposite end of silver cross pole and gradually apply pressure to the pole forming an arch. Insert the end of pole into the grommet at other side of tent. (Fig. 2)

11.Repeat for second silver cross pole forming an “X”. (Fig.2)

2B

Door

Stake through

loop2C

Stake through	Red Main
loop
	Pole in first
		Fig. 2
	grommet

2A

12.Attach frame clips along edges of tent to red and silver poles. (Fig. 2 & 2B)

13.Clip plastic hooks, located on both sides of tent, to secure silver cross poles together as shown. (Fig. 2 & 2C)

14.Stretch sides of tent until floor is taut then hammer stakes through loops on web straps to secure.

(continued on other side)