KVIKATM TENT 8’ X 8’ MODEL 2000001059
STITCH LINE
Before you begin
Read all instructions before set up.
•Select a level campsite clear of rocks, branches, and other hard or sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
•Do not set up your tent under trees.
•For best results in windy conditions, position end of tent into the wind.
•Enlist the help of at least one other person to assist you when it is time to assemble the tent.
Parts and Components
Description | Part Number |
Main Poles, Black (2) | 5010000360 |
Side Poles, Gray (2) | 5010000361 |
Rainfly | 5010000362 |
To Set Up Tent
1.Unfold tent and spread out on a clean, level surface with the door facing the desired direction. Unzip door. (Fig. 1)
Fig. 1
Door
2. Assemble main tent poles by interlocking both longer, black
3. Insert black poles through sleeves, with the black seams, in top of tent forming an “X” as shown. (Fig. 2)
Fig. 2
Sleeves with black seams
4. Insert one end of each black pole into |
| Fig. 3 |
pins in front corners oftent. (Fig. 3) |
|
|
|
| |
|
|
|
5.Go to opposite end of each pole and gradually apply pressure to the pole forming an arch. Insert the pin into the pole end at the tent corners.
(Fig. 4)
6.Stretch corners of tent until floor is taut then hammer stakes through loops to secure.
Fig. 4
To Set Up Tent (continued)
7.Attach frame clips along edges of tent to black main poles (Fig. 5)
8.Assemble first interlocking
Fig. 5
9.Slide the gray pole through sleeve on front of tent. (Fig. 6)
Fig. 6
10. Pull down on pole and insert into |
|
|
|
| ||
center pin location on side of tent. |
|
|
|
| ||
(Fig. 7) |
|
|
|
| ||
11. Go to opposite side of tent and |
|
|
|
| ||
gradually apply pressure to the |
|
|
|
| ||
pole to form an arch. Insert the |
|
|
|
| ||
pin into the pole, then drive stake |
|
|
|
| ||
through metal ring to secure. |
|
|
|
| ||
12. Attach frame clips on both sides |
|
|
|
| ||
|
|
| Fig. 7 | |||
of tent to gray pole. |
|
|
| |||
|
|
|
| |||
|
|
|
| |||
|
|
|
|
|
| |
To Attach Rainfly |
|
|
|
| ||
1. Drape rainfly over tent with vestibule centered over the door | ||||||
on the front of tent (Fig 8). |
|
|
|
| ||
NOTE: Hook and loop |
|
|
|
|
| |
|
|
|
| Fig. 8 | ||
fasteners, located on |
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
| |||
seams of underside |
|
|
|
|
| |
of rainfly, should be |
|
|
|
|
| |
centered over black |
|
|
|
|
| |
and gray poles. |
|
| Vestibule | |||
|
|
|
| |||
|
|
|
| on Rainfly | ||
|
|
|
| Front on Tent | ||
2. Secure rainfly with velcro hook |
|
|
|
|
| |
|
|
|
|
| ||
& loop fasteners, on underside |
|
|
|
|
| |
of rainfly, around black poles at |
|
|
|
|
| |
the back of tent and gray pole |
|
|
|
|
| |
on both sides. (Fig. 9) |
|
|
|
|
| |
|
|
|
|
| ||
|
|
| Fig. 9 |
|
| |
|
|
|
|
|
|
|
3. | Assemble remaining interlock- | Sleeve | |
| ing | in Rainfly | |
4. | Fold back vestibule on front of |
|
|
| tent to locate sleeve on under |
|
|
| side of rainfly. (Fig. 9) |
|
|
5. | Slide gray pole through sleeve |
|
|
| in rainfly. (Fig. 9) |
|
|
|
|
|
|
|
|
| Fig. 10 |
|
|
|
|
| (continued on other side) |