To Set Up cont.
• Close Front Propane Access Door
Use and Operation
•Clean before first use. It is strongly recommended that you clean the heater prior to using for the first time. Follow these simple steps before you leave home, and then clean at least once a year or when the hose becomes discolored with a white calcium build up.
Cleaning instructions:
1.In a clean container mix
12 oz. of calcium, lime, and rust remover (available at the cleaner section of hardware, general merchandise and food stores).
2.Place the pump in the container with the water/solu- tion. The label “This Side Up” on pump should be facing up. (Fig. 3)
3.Position the container with the water/solution so that it is placed under the faucet.
4.Push and turn the control knob and position the knob at the “warm” setting. (Fig. 4)
5.Circulate the water/solution through the water heater for 2 minutes, then turn off heater by turning the knob clockwise to the “off” position. (Fig. 5)
6.Dispose of the cleaning solution in a sink or other drain, do not dump on the ground.
7.Fill container with 2 1/2 gallons of clean water.
8.Place the pump in the container with the water.
9.Position the water heater so the container with the water is placed under the faucet.
10.Turn the heater on by pushing and turning the control knob and position to the “cool” setting. (Fig. 6)
11.Circulate the clean water through the water heater for 2 minutes, then turn the knob clockwise to turn the heater off. (Fig. 7)
12.Repeat steps
•Rotate Faucet out- ward from the stored position and place a water collec- tion basin under faucet.
Fig. 3
Fig. 5
Fig. 7
Fig. 4
Fig. 6
6
Hot Water on DemandTM unit is now clean and ready for use.
