Coleman 5344 warranty To Install or Replace Batteries, To Operate, Things YOU should Know

TO INSTALL OR REPLACE BATTERIES

Your new lantern operates on 6 “D” cell batteries. For longest life, use alkaline batteries.

1.	With lantern off, turn upside down and unscrew base by rotating counterclockwise
	then lift off base. (Fig. 1)
2.	Press in tab and open battery cover. (Fig. 2)
3.	Install 6 batteries in the correct orientation as shown on the battery housing.

TO OPERATE

Your Coleman® Personal Twin Tube Lantern has a three position switch:

•The center position is OFF.

•Turn the knob counterclockwise to I and only the left tube will light. (Fig. 6)

•Turn the knob clockwise to II and both tubes will light for maximum light output. (Fig. 7)

Always be careful that all 6 batteries are installed correctly. (Fig. 3)

4. Close battery cover then replace base and turn clockwise until hand tight. Check

that base is securely installed in closed position.

NOTE: The time that the lantern will operate depends on how it is used. On new alkaline batteries, the run times are as follows:

•14 hours with both tubes (II) turned on constantly

•25 hours with one tube (I) turned on constantly

OFF OFF

Fig. 6 Fig. 7

Fig. 1 TAB Fig. 2 Fig. 3

THINGS YOU SHOULD KNOW

1.	Operating time for this lantern depends on whether it is run continuously or
	intermittently. Intermittent operation extends the run time of a set of batteries.
2.	In cold temperatures, the fluorescent tube is more difficult to light and may be
	dim until it warms up. Below 20˚F (-7˚C), the bulb may not light.

TO CHANGE FLUORESCENT BULB

NOTE: This lantern uses two standard 6 inch (15.2 cm), 4-watt fluorescent tubes.

(See Parts List for replacement #).

1.With lantern in normal upright position, remove top

cover by rotating counterclockwise until the index mark is at OPEN position. (Fig. 4)

2.Lift off cover and remove old tube(s).

3.Install new 6 inch, 4 watt fluorescent tube(s). (Fig. 5)

4.Replace top cover and turn clockwise until the index markis at CLOSE position. (Fig. 4)

Fluorescent tube(s) contains mercury (Hg) and must be recycled or disposed of according to local, state or federal laws. Call (800) 835-3278 or visit www.coleman.com/recycle for recycling instructions or safe disposal locations.

OPENCLOSE

OPENCLOSE

Fig. 4

Fig. 5

3.	When the fluorescent tubes are not lit to full brilliance, batteries should be
	replaced. If this is not done and lantern is used, the tubes will become blackened.
4.	IMPORTANT: Do not leave discharged batteries in the lantern for an extended
	period of time as this could permanently damage the lantern.
5.	To clean the outside of the lantern and globe, use only a damp cloth and mild
	dishwashing liquid. Avoid excessive water and strong cleaner which can damage
	the lantern.

Parts List

1. 5010000350 4-watt Fluorescent Tube

1