Always fill outdoors. Never fill lantern, loosen or
remove fuel cap while lantern is lighted, near flame
(including pilot lights), other ignition sources, or while
top of lantern is hot to touch.
1. Turn FUELVALVE to “OFF”.(Fig. 1)
2. Close PUMPKNOB firmly. Turn in direction of
arrow.(Fig. 2)
3. Remove FUEL CAP.Use a Coleman®filter funnel
and fill with clean, fresh fuel. Lantern must be in a
level position.DO NOT TIP.(Fig. 3)
4. Replace FUEL CAP on lantern and on fuel
container. Tighten firmly.WIPE UP ANY SPILLED
FUEL AND DISPOSE OF IN A SAFE PLACE.
1. Turn FUELVALVE to “OFF”.Light will
dim and go out in about 1-2 minutes.
1. Be sure FUELVALVE is “Off” and fuel cap is
closed firmly.
2. Open PUMPKNOB one tur n.
3. With thumb over hole in PUMPKNOB, pump
approximately 30 strokes.If lantern is not full of
fuel, more pump strokes are required. GOOD
AIRPRESSURE IS IMPORTANT.
4. Close PUMPKNOB firmly.