Coleman 9145-171CD manual Door and Window Vents, Cooler Access, Electrical Cord Access, To Store

To Attach Rainfly continued

9.Secure rainfly with velcro hook & loop located on underside of fly. (Fig 14)

10.Tie guylines onto web straps located on the rainfly, stretch until taut, and secure

with stakes. (Fig 15 & 16) Fig. 14

Fig. 15

Fig. 16

11.Extend front flaps on rainfly and secure with stakes. Note: Flaps may be rolled back and and secured by inserting toggles through fabric loops.

Door and Window Vents

1.Assemble Vertical Hinge Door pole (shorter black pole with plastic cap tips); insert into zippered vertical pocket on hinged side of door. (Fig. 17)

2.Assemble Hinge Door pole (longer black pole with plastic cap tips) insert into zippered pocket at bottom of door. (Fig. 18)

3.Insert ends of both door poles into sockets at top and bottom of door on hinged side. (Fig. 19)

Fig. 17 Fig. 18 Fig. 19

4.For better ventilation, unnzip flap on door, roll down, and insert toggle into fabric loop to secure. (Fig. 20)

5.To open back and side window vents for more ventilation, unzip, then roll up and insert toggles through fabric loops.

(Fig. 21 & 22) Fig. 20

Fig. 21 Fig. 22

Cooler Access

The smaller zippered opening at the rear of the tent is designed for added ventilation and easy access to your beverage cooler.

1. To use as a vent, unzip flap toFig. 23 expose screen. (Fig.23)

2.To use as a cooler access, unzip other flap to make an avenue to bring beverages into the tent.

(Fig.24)

Fig. 24

Electrical Cord Access

1.Unzip access panel in the lower right corner of tent and bring in electrical cord. Use only UL approved cords that are rated for outdoor usage. (Fig. 25)

Fig. 25

Attaching Dividers

1.Divider panels can be installed on left or right sides of the tent by inserting toggles through the fabric loops.

(Fig. 26 & 27)

Fig. 26 Fig. 27

To Store

1.All metal poles and stakes must to be placed in the storage bag to prevent damage to the fabric items placed in the carry case.

2.Make sure tent is clean and dry before placing in carry case.

3.Remove rainfly, spread out on floor of tent, then unzip door & vents before taking tent down for storage.

4.Neatly fold tent to width of pole storage bag, place on tent, roll tightly, and place in carry case.

5.Store in a clean, dry area.

Things You Should Know:

•Under certain conditions (cold weather, high humidity, etc.) condensa- tion will form on the inside of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventila- tion through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•Stakes should be removed by pulling on the stake itself. Never pull on the tent to remove stake.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

•Do not leave your tent set-up for weeks at a time. Be aware that exposure to ultraviolet rays from the sun can seriously damage material and/or cause it to become discolored.

WARNING: Keep all flame and heat sources away from this tent fabric.

This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 in the United States • www.coleman.com

Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions

20B Hereford Street, Brampton, Ontario, Canada L6Y 0M1

1 800 387-6161 in Canada • www.coleman.com

MADE IN CHINA • PRINTED IN CHINA

	© 2007 The Coleman Company, Inc.
Coleman® and	are registered trademarks of The Coleman Company, Inc.	12/07

STITCH LINE