Coleman 9232-107 manual Attach Tent Rainflys, Connecting Room

4

5

Attach Tent Rainflys	illus. 6 Insert rainfly pole piece into
	pockets on underside of rainfly
– Assemble tent rainfly poles by
interlocking shock-corded pole.	Underside of rainfly
– Insert rainfly pole into the pole pocket	attaches to tent frame
located at the center edges of the
underside of rainfly. (illus. 6), (illus. 7)
– Drape rainfly over tent frame, pole side
down. Rainfly pole should be over door
and rear window. NOTE: The toggles on
the rainfly need to run from the front
corners to the top of the tent.
– Connect the four elastic loops with hooks,
(found at the rainfly corners) to the fabric
loops on the bottom row of frame clips.

–Secure rainfly with attachments located on underside of fly. (illus. 7)

– Repeat for second tent.	illus. 7			illus. 8
				Hooks attaches to
	Both tents fully assembled with rainflys
Connecting Room				fabric loop
		Center ridge
– Layout connecting room and assemble center
		pole sleeves
ridge and side poles.		Pole
– Insert the center ridge pole (gray) through ridge
		pocket
pole sleeves and insert the pole ends into the
pole pockets. (illus. 9)		illus. 9
– Insert the side poles through the pole sleeves
		Connecting room
on connecting room. (illus. 9) Position
		with center ridge pole
connecting room between tents, pole side up.
		and side poles in position
– Insert one end of side pole onto pin of pin & ring				Toggles & Loops
system on the stability strap. (illus. 3)
				secure connecting
– Go to opposite end of pole and gradually apply
				room to tents
pressure to the pole forming an arch until
you are able to insert the pin into the pole.
– Repeat for second pole. (illus. 9), (illus. 10)
– Move tent as needed for better fit with
connecting room. Fully stake down tents.
– Attach connecting room to the tents with
toggles & loops on rainfly and hooking the
stake loop ring at the tent corners. (illus. 10)
– Stake out the tents with (2) side guylines			Stability Guylines
each and the connecting room with				strap

(4) guylines. (illus. 8) illus. 10 Both tents and connecting room completed

Things You Should Know

•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

•Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.

PRINTED IN THAILAND Rev. 10/04

•Do not leave your tent set-up for weeks at a time, be aware that expo- sure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric will burn if left in continuous con- tact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN THAILAND